Quick Overview
The Punch P600x4 multi-channel amplifier is versatile to power any audio system configuration. In addition to 4-channel stereo mode, you can bridge both channels to create a high power 2-channel amp, or run stereo speakers on the front with subwoofers on the rear in 3-channel mode.
Details
Rated Power:
Continuous power: 75W x 4 @ 4 Ohms RMS
150W x 4 @ 2 Ohms RMS 300 Watts x 2 @ 4-Ohm Bridged
Total Power: 600 Watts
Dynamic Power: 129 Watts x 4 @ 4-Ohms 0° Res
211 Watts x 2 @ 2-Ohms 0° Res
Bridgeable: Yes
Efficiency (average): 68% @ 4 Ohm
Crossover Controls:Front High-Pass (HP): 50Hz-250Hz 12dB/octave Butterworth Front Low-Pass (LP): 50-250Hz 12dB/octave Butterworth Rear High-Pass (HP): 50Hz-250Hz 12dB/octave Butterworth Rear Low-Pass (LP): 50-250Hz 12dB/octave Butterworth
Tone Controls: Front Punch EQ2 Bass: 0dB to +18dB @ 45Hz and/or Front Punch EQ2 Treble: 0dB to +12.5dB @ 12kHz Rear Punch EQ2 Bass: 0dB to +18dB @ 45Hz and/or Rear Punch EQ2 Treble: 0dB to +12.5dB @ 12kHz Function depends upon LP/AP/HP switch position
Signal Input: Hi/Low Level: 2 RCA Pair
Signal Output: Low Level: 1 RCA Pair
Power Input Connector: Captive C-Clamp
Power Wire Gauge: 4 AWG
Speaker Output Connector: Captive C-Clamp
Speaker Wire Gauge: 8 AWG to 18 AWG
Heat Sink Type: Cast aluminum
Cooling: Convection
Remote Controls: Optional Punch Level Control (PLC2) Ready
Visual Indicators: Power/Protect/Thermal LED Input Clip LED Output Clip LED
Circuit Topology Class: Class A/B
Frequency Response: 20Hz to 20kHz +/- 1.0dB
Dimensions (HxWxL) 2.4 x 7.8 x 13.3 (in)
 |